The Ultimate Guide to Operating the Grouting Reinforcement Drilling Machine: Essential Tips for Beginners!

For novice operators of the grouting reinforcement drilling machine, it is crucial to master some techniques. Before operation, thoroughly inspect all components of the drilling machine to ensure they are in good condition. Start by conducting a no-load test run of the drilling machine to check for smooth rotation and feed, as well as for any abnormal vibrations or noises. Observe the forward and reverse rotation of the motor to confirm it is in the correct direction. During drilling, adjust the water injection pressure and flow rate to ensure a stable water flow and prevent excessive pressure from causing the stratum to split or the grout from spilling out. Control the drilling speed carefully; do not go too fast or too slow. Going too fast can damage the drill bit, while going too slow will affect efficiency. Note: When shifting gears, you must stop the machine, switch gears, turn off the power switch, change the gear position, and after the shift is complete, turn on the power. Adjust the drilling pressure according to the geological conditions. Increase the pressure appropriately for hard soil layers and reduce it for soft soil layers. During the grouting process, pay attention to observing the changes in grouting volume and pressure, and maintain uniform grouting. After the operation is completed, promptly clean the drilling machine and perform maintenance on key parts. This will extend the service life of the drilling machine and ensure a smoother construction process.